Scrub and recoat in Fort Wayne, Indiana
When the traffic lanes go flat but the finish underneath is still sound, a scrub and recoat is the smart middle move for Fort Wayne floors. We machine-scrub off the worn top layer and lay one or two fresh coats, no full strip required.
Scrub and recoat, explained
Scrub and recoat sits between burnishing and a full strip. Burnishing only polishes; a full strip removes everything. Scrub and recoat takes off just the worn top layer and adds fresh coats, so you get a renewed finish for a fraction of the disruption.
It is the right call when:
- The gloss has gone flat in the traffic lanes but the finish is not yellowed
- You want to refresh the look without a full strip
- The floor is on a program and just needs its coats topped up
Not sure? The full comparison lays out all three side by side. It is a favorite for offices that cannot afford downtime.
What does scrub and recoat cost in Fort Wayne?
Scrub and recoat is quoted per square foot and lands between the cost of burnishing and a full strip and wax. Because far less labor and material go into it than a strip, it is the cost-effective way to keep floors looking recoated year-round. Small areas may fall under a minimum job size.
A common rhythm is to burnish through the year, scrub and recoat a couple of times, and do one full strip over the summer, keeping the finish ahead of the traffic and the winter salt. That same rhythm works anywhere we serve, including New Haven, Columbia City, and the rest of Allen County.
Refresh the finish before it wears through.
A scrub and recoat now saves a strip later. Free walkthrough, written quote.
Common Questions
What is a scrub and recoat?
A scrub and recoat removes the worn top layer of finish with a machine, then lays one or two fresh coats over the coats still good. It refreshes the gloss and adds protection without stripping to the tile.
When should I choose scrub and recoat instead of strip and wax?
Choose it when the finish is worn or dull but not yellowed or badly built up. It is faster, cheaper, and less disruptive than a full strip, and it stretches the time until you need one.
How long does a scrub and recoat take to dry?
The new coats are usually walkable a few hours after the last one goes down, and we schedule the work after hours so the floor is ready before you open. Keep mats and heavy loads off it for about a day.
How often do we need a scrub and recoat?
Many commercial floors get one a few times a year, between full strips. On a plan we time it so the finish is refreshed before it wears through to the tile.
Request a Free Floor Walkthrough
Tell us about your facility and your floors. We will schedule a walkthrough, measure the space, and send a written per-square-foot quote. No pressure and no obligation.
- A real number you can compare against other bids
- Work scheduled around your hours, not ours
- A plan to keep the floor up, not just a one-time job
Answered during business hours. After hours, leave a message and we call back the next business day.